Owner's manual

4 QUALITY ASSURANCE PROVISIONS
4.1 General.
The quality assurance provisions shall be in accordance with the General Specification with
the exceptions, modifications, and additions specified herein.
4.2 Screening tests.
The screening tests shall be in accordance with the General Specification.
4.3 Quality
Conformance Inspection. Quality Conformance Inspection shall be in accordance with the
General Specification and shall be required only when specified by the purchase order.
5 PACKAGING
5.1 Preservation, packaging and packing.
Hybrid crystal oscillators shall be prepared for delivery in
accordance with the General specification.
6 NOTES
6.1 Notes.
The notes of the General Specification are applicable to this drawing.
6.2 Ordering information.
The procuring activity shall advise Q-Tech Corporation at the time of Request
for Quotation if quality conformance inspection is to be required.
6.3 Part number
.
QT625 L B M - 16.000000 MHZ
Model #
Supply voltage: L: + 3.3 volts
Temp stability - see Table I
Screening: E: engineering model; M: flight model
Frequency (8 digits)
± 5 PPM, 0 °C TO + 55 °C
H *
± 25 PPM, - 20 °C TO + 70 °C
G
± 50 PPM, - 20 °C TO + 70 °C
F
± 30 PPM, - 40 °C TO + 85 °C
E
± 40 PPM, - 55 °C TO + 105 °C
D
± 50 PPM, - 55 °C TO + 105 °C
C
± 50 PPM, - 55 °C TO + 125 °C
B
± 65 PPM, - 55 °C TO + 125 °C
A
TEMP STABILITYOPTION
TABLE I. STABILITY / TEMPERATURE OPTIONS *
* Frequency/Temperature stability (tolerance) shall be referenced to the specified nominal output
frequency, except for temp code H, in which case it is with reference to room temperature (T = 25 ±
2 °C). For temp code H, room temperature tolerance shall be ±10 PPM.
7 SOURCE OF SUPPLY
7.1 Approved manufacturer.
Q-Tech Corporation
10150 W. Jefferson Blvd.
Culver City, Ca. 90232 U.S.A.
THIS DOCUMENT IS CONSIDERED PROPRIETARY TO Q-TECH CORPORATION
DO NOT COPY OR DISTRIBUTE WITHOUT Q-TECH CORPORATION APPROVAL
Q-Tech Corporation
10150 W. Jefferson Blvd.
Culver City, CA. 90232
Specification number: QT625L rev. F
Sheet 3 of 5