Instructions / Assembly
7. Electrical Installation Of Spa After Delivery
(220/240 Volt Spas) Important Safety notice for all models!
Proper grounding is extremely important.
For QCA Spas
Control Packs
VS 300
VS 501
VS 515
QC 2000
1. To gain access to the spa’s control box, remove the cabinet
access panel on the front of the spa, under the spas topside
control. After removing the access panel, remove the two
control box cover screws and cover.
2. Select the power wire inlet through the spa cabinet you want
to use. (Either drill a hole through the cabinet or run wire in
conduit through the base of the spa.) Then feed the power cable
through it to the left side of the control box.
3. Run power wire through the circular hole on the left side of the
control box.
4. Connect wires, color to color, into the terminal openings and
tighten securely. Connect ground wire to the ground terminal and
tighten securely.
5. Secure the control box door by installing its screws, then
re-install the cabinet access panel under the topside control.
Electrical installation is now complete.
USE COPPER 240V
WIRE MIN. 6AWG. 40A 60HZ
S
Y
S
T
E
M
B
O
X
Neutral Hot Hot Ground
W
H
T
B
L
K
R
E
D
G
R
N
CIRCUIT BOARD
GROUND
WHITE (NEUTRAL)
BLK (HOT)
RED (HOT)
GREEN (GROUND)
TB1
BP501
BP2000
BP600
BP2001
17