ENJOY Your QCA Spa (Dream Series) in.k200 Spa Pak To be used with the Model 0, Model 0H, Model 1P, Model 14P, and Model 2P OWNER’S MANUAL This owner’s manual is for YOU! It will show you how to operate and maintain your very own spa. We think it is important for you to take a few moments and get acquainted with your new spa operation. Please keep this manual available for references. QCA Spas would like to congratulate you on your purchase and we sincerely hope you enjoy your QCA Spa.
TABLE OF CONTENTS Air Control…………………………………………………………………….6 Cleaning the Filter Cartridge ................................................................. 7 Diagnostic Messages ............................................................................. 6 Filter Maintenance ................................................................................. 7 Hyperthermia Description ...................................................................... 3 Initial Start Up ......................................
a. The water in a spa or hot tub should never exceed 104F (40C). Water temperatures between 100F (38C) and 104F (40C) are considered safe for a healthy adult. Lower water temperatures are recommended for extended use (exceeding 10-15 minutes) and for young children. IMPORTANT SAFETY INSTRUCTIONS When installing and using this electrical equipment, remember to always observe safety precautions, including the following: 1. READ AND INSTRUCTIONS. FOLLOW ALL 2a.
Spa Location The selection of a site for the installation of your spa is a very important decision and should be undertaken keeping several factors in mind. 8. Before filling with water, be sure the spa is in its final position and that hoses, tools, etc. are not under the spa. 1. Always check your local codes before installing your spa. A clear understanding of buildings, fences, gates, electrical and plumbing guidelines will be invaluable. THIS SYSTEM COMES WITH A PREWIRED GFCI IN-LINE CORD.
YOUR • QCA • SPA • EQUIPMENT in.k200 Control Pump Key 1 Press Key 1 key to turn Pump 1 on at low speed. Press a second time to turn pump to high speed (with a dualspeed pump, if included in your spa). A third time turns pump off (second time for a one speed pump.) A built-in timer automatically turns pump off after a predetermined period of time, unless pump has been manually deactivated first. The “Pump 1” indicator lights up when Pump 1 is on.
Diagnostic Messages Message Meaning No message on display. Power has been cut off to the Spa. Hr An internal hardware error has been detected in in.xe HL The system has shut the heater down because the temperature at the heater has reached 119°F (48°C). AOH FLO Prr OH Action Required The control panel will be disabled until power returns. Spa settings will be preserved until next power up. Contact dealer or service supplier. DO NOT ENTER THE WATER. Remove the spa cover and allow the water to cool.
chlorine shock to destroy any organic contaminants that may have accumulated in the spa during filling. • Step 4: A bromine residual of 2.0 - 4.0 ppm, as determined by your test kit, should be maintained at all times. We suggest you follow a regular maintenance program to keep your spa water fresh and crystal clear. Filter Maintenance As with any water filtering system, the filter cartridges may become clogged with particles or with calcification that will result in reduced water flow.
local dealer. Soak the cartridge for 24 hours to remove body oils and body lotions that become impregnated in the cartridge fabric during filtration. Rinse the cartridge thoroughly before placing it back into the filter housing. The QCA Spa has been designed and engineered for year-round use in any climate. The energy efficiency of the spa may decrease during these cold periods. If a freeze condition is detected, the pump is automatically activated.
protection, sealed. cabinets must be moisture WARRANTY REGISTRATION This warranty applies to spas manufactured by QCA DREAM SERIES™ Spas and sold to an original consumer purchaser at retail ("Purchaser") after June 1, 1998. To validate this warranty, the Purchaser must complete the enclosed warranty registration card and mail it to QCA/DREAM SERIES™ within 30 days of deliver of the spa. RETURN OF THE OWNER REGISTRATION CARD IS A CONDITION OF WARRANTY COVERAGE.
Troubleshooting Please Note: the spa owner may perform the following corrective actions. If the trouble cannot be corrected in the steps below, please refer to your QCA Dealer for service. (Improper servicing by an unauthorized serviceman or spa owner could result in damage that will not be covered by the warranty, or could cause serious injury.) SYMPTOMS CORRECTIVE ACTION Equipment Does Not Operate Check to see if the power cord is plugged in. Test the GFCI to see if it has "tripped.
To receive your FREE gift to help maintain your spa and to VALIDATE your spa warranty, return the PREPAID registration card below within the next THIRTY days. To immediately register your new spa; you may log onto our web site at qcaspas.
