Use and Care Guide

5
in.k200 Control
Pump Key 1
Press Key 1 key to turn Pump 1 on at low speed. Press
a second time to turn pump to high speed (with a dual-
speed pump, if included in your spa). A third time
turns pump off (second time for a one speed pump.) A
built-in timer automatically turns pump off after a
predetermined period of time, unless pump has been
manually deactivated first. The “Pump 1” indicator
lights up when Pump 1 is on. With dual-speed pump,
indicator will flash when Pump 1 is on at low speed.
Light Key
If your spa includes a light, press Light key to turn
light on. Press a second time to turn light off. A built-
in timer automatically turns light off after 2 hours,
unless it has been manually deactivated first. The
“Light” indicator lights up when light is on.
Up/Down Keys
Use Up or Down key to set desired water temperature.
The temperature setting will be displayed for 5
seconds to confirm your new selection. The "Set
Point" icon indicates that the display shows the desired
temperature, NOT the current water temperature!
Off Mode
This mode allows you to stop all outputs for 30
minutes to perform a quick spa maintenance. Press and
hold Key 1 key for 5 seconds to activate the Off mode.
Quick press Key 1 key to reactivate the system before
the expiration of the 30-minute delay. While the Off
mode is engaged, the display will toggle between OFF
and the water temperature.
Setting the Temperature Display Units
Quick press Light key again. The display will show
either °F or °C. Use Up or Down key to change units.
Press Light key a last time to go back to normal mode.
°F = Fahrenheit
°C = Celsius
Setting Filter Cycle Duration
Press and hold Light key until the display shows dxx,
with "xx" representing the duration in hours. (Default:
2 hours). Use Up or Down key to change setting.
0 = no filtration
24 = continuous filtration
Note: it's not recommended to set this to "0".
Filter Cycle Frequency
Press Light key again. The display will show Fx, with
"x" representing the number of filter cycles per day (up
to 4). (Default: twice a day). Use Up or Down key to
change setting. When the desired setting is displayed,
press Light key to confirm. A filter cycle will start
immediately. The “Filter” indicator lights up when a
filter cycle is on.
Programming Purge Cycles
To program the purge cycles, you must select the
frequency. During a purge cycle, all pumps and the
blower run for one minute. To set purge cycles:
Purge cycle frequency
Press and hold Light key until the display shows Fx,
with "x" representing the number of purge cycles per
day (up to 4). Use Up or Down key to change setting.
When the desired setting is displayed, press Light key
to confirm. A purge cycle will start immediately. The
“Filter” indicator lights up when a purge cycle is on
Water Temperature Regulation
If your spa includes a heater, after verifying pump
activation and taking a water temperature reading if
required, the system automatically turns the heater on
to reach and maintain water temperature at Set Point.
The “Heater” indicator lights up when the heater is on.
It flashes when there is a request for more heat but the
heater has not yet started.
Smart Winter Mode
Our Smart Winter Mode protects your system from the
cold by turning pumps on several times a day to
prevent water from freezing in pipes. The “Smart
Winter Mode” indicator lights up when the Smart
Winter Mode is on.
YOUR • QCA • SPA • EQUIPMENT