Installation guide

B – Command Line Interface
Group Command
59042-08 A B-25
0
Keywords add [group]
Initiates an editing session in which to specify a group member and its attributes
for the existing group given by [group]. ISL, Port, and MS member attributes are
described in Table B-5, Tab le B-6, and Table B-7 respectively. The group name
and group type attributes are read-only fields common to all three tables.
Table B-5. ISL Group Member Attributes
Attribute Description
Member Worldwide name of the switch that would attach to the switch. A
member cannot belong to more than one group.
Authentication Enables (CHAP) or disables (None) authentication using the
Challenge Handshake Authentication Protocol (CHAP). The
default is None.
Primary Hash The preferred hash function to use to decipher the encrypted
Primary Secret sent by the ISL member. The hash functions are
MD5 or SHA-1. If the ISL member does not support the Primary
Hash, the switch will use the Secondary Hash.
Primary
Secret
Hexadecimal string that is encrypted by the Primary Hash for
authentication with the ISL group member. The string has the
following lengths depending on the Primary Hash function:
 MD5 hash: 16-byte
 SHA-1 hash: 20-byte
Secondary
Hash
Hash function to use to decipher the encrypted Secondary Secret
sent by the ISL group member. Hash values are MD5 or SHA-1.
The Secondary Hash is used when the Primary Hash is not
available on the ISL group member. The Primary Hash and the
Secondary Hash cannot be the same.
Secondary
Secret
Hex string that is encrypted by the Secondary Hash and sent for
authentication. The string has the following lengths depending on
the Secondary Hash function:
 MD5 hash: 16-byte
 SHA-1 hash: 20-byte
Binding Domain ID of the switch to which to bind the ISL group member
worldwide name. This option is available only if
FabricBindingEnabled is set to True using the Set Config Security
command. Refer to the “Set Config Command” on page B-60.
0 (zero) specifies no binding.