Installation guide

B – Command Line Interface
Set Config Command
59042-08 A B-61
0
SymbolicPortName Descriptive name for the port. The name can be up to 32
characters excluding #, semicolon (;), and comma (,). The
default is Port n where n is the port number.
ALFairness Arbitration loop fairness. Enables (True) or disables
(False) the switch’s priority to arbitrate on the loop. The
default is False.
DeviceScanEnabled Enables (True) or disables (False) the scanning of the
connected device for FC-4 descriptor information during
login. The default is True.
ForceOfflineRSCN Enables (False) or disables (True) the immediate
transmission of RSCN messages when communication
between a port and a device is interrupted. If enabled, the
RSCN message is delayed for 200 ms for locally attached
devices and 400 ms for devices connected through other
switches. The default is False. This parameter is ignored if
IOStreamGuard is enabled.
ARB_FF Send ARB_FF (True) instead of IDLEs (False) on the loop.
The default is False.
InteropCredit Interoperability credit. The number of buffer-to-buffer
credits per port. 0 means the default (12) is unchanged.
Changing interoperability credits is necessary only for
E_Ports that are connected to non-FC-SW-2-compliant
switches. Contact your authorized maintenance provider
for assistance in using this feature.
ExtCredit Extended credits. The number of port buffer credits that
this port can acquire from donor ports. The default is 0.
FANEnable Fabric address notification. Enables (True) or disables
(False) the communication of the FL_Port address, port
name, and node name to the logged-in NL_Port. The
default is True.
AutoPerfTuning Automatic performance tuning for FL_Ports only. The
default is True.
 If AutoPerfTuning is enabled (True) and the port is an
FL_Port, MFSEnable is automatically enabled.
LCFEnable and VIEnable are overridden to False.
 If AutoPerfTuning is disabled (False), MFSEnable,
LCFEnable, and VIEnable retain their original values.
Table B-18. Set Config Port Parameters (Continued)
Parameter Description