Installation guide

B – Command Line Interface
Set Config Command
59042-08 A B-63
0
security
Initiates an editing session in which to change the security settings. The system
displays each parameter one line at a time and prompts you for a value. For each
parameter, enter a new value or press the Enter key to accept the current value
shown in brackets. Enter “q” or "Q" to end the editing session. Table B-1 9
describes the Set Config Security parameters.
switch
Initiates an editing session in which to change switch configuration settings. The
system displays each parameter one line at a time and prompts you for a value.
For each parameter, enter a new value or press the Enter key to accept the
current value shown in brackets. Table B-20 describes the Set Config Switch
parameters.
Table B-19. Security Configuration Parameters
Parameter Description
AutoSave Enables (True) or disables (False) the saving of
changes to active security set in the switch’s
permanent memory. The default is True.
FabricBindingEnabled Enables (True) or disables (False) the configuration
and enforcement of fabric binding on all switches the
fabric. Fabric binding associates switch worldwide
names with a domain ID in the creation of ISL groups.
Table B-20. Set Config Switch Parameters
Parameter Description
AdminState Switch administrative state: online, offline, or
diagnostics. The default is Online.
BroadcastEnabled Broadcast. Enables (True) or disables (False)
forwarding of broadcast frames. The default is
True.
InbandEnabled Inband management. Enables (True) or disables
(False) the ability to manage the switch over an
ISL. The default is True.
FDMIEnabled Fabric Device Monitoring Interface. Enables (True)
or disables (False) the monitoring of target and
initiator device information. The default is True.
FDMIEntries The number of device entries to maintain in the
FDMI database. Enter a number from 0–1000. The
default is 1000.