Installation guide

B – Command Line Interface
Set Config Command
B-64 59042-08 A
0
DefaultDomainID Default domain ID. The default is 1.
DomainIDLock Prevents (True) or allows (False) dynamic
reassignment of the domain ID. The default is
False.
SymbolicName Descriptive name for the switch. The name can be
up to 32 characters excluding #, semicolon (;), and
comma (,). The default is SANbox2.
R_A_TOV Resource Allocation Timeout Value. The number
of milliseconds the switch waits to allow two ports
to allocate enough resources to establish a link.
The default is 10000.
E_D_TOV Error Detect Timeout Value. The number of
milliseconds a port is to wait for errors to clear. The
default is 2000.
PrincipalPriority The priority used in the FC-SW-2 principal switch
selection algorithm. 1 is high, 255 is low. The
default is 254.
ConfigDescription Switch configuration description. The configuration
description can be up to 32 characters excluding
#, semicolon (;), and comma (,). The default is
Config Default.
InteropMode Propagates just the active zone set throughout the
fabric (Standard, FC-SW-2 compliant) or the entire
zoning database (Interop-1, non-compliant). The
default is Standard.
LegacyAddressFormat Available only when the InteropMode parameter is
Interop-1, this parameter enables (True) or
disables (False) the use of legacy address
formatting for interoperating with non-FC-SW-2
switches. The default is False.
Table B-20. Set Config Switch Parameters (Continued)
Parameter Description