Installation guide

B – Command Line Interface
Set Setup Command
B-80 59042-08 A
0
EmbeddedGUIEnabled Enables (True) or disables (False) the SANsurfer Switch
Manager web applet. The web applet enables you to
point at a switch with an internet browser and run
SANsurfer Switch Manager through the browser. This
parameter is the master control for the Set Setup
System command parameter, EmbeddedGUIEnabled.
The default is True.
SNMPEnabled Enables (True) or disables (False) the management of
the switch through third-party applications that use the
Simple Network Management Protocol (SNMP). This
parameter is the master control for the Set Setup SNMP
command parameter, SNMPEnabled. The default is
True.
NTPEnabled Enables (True) or disables (False) the Network Time
Protocol (NTP) which allows the synchronizing of switch
and workstation dates and times with an NTP server.
This helps to prevent invalid SSL certificates and
timestamp confusion in the event log. The default is
False. This parameter is the master control for the Set
Setup System command parameter, NTPClientEnabled.
The default is False.
CIMEnabled Enables (True) or disables (False) the management of
the switch through third-party applications that use the
Common Information Model (CIM). The default is True.
FTPEnabled Enables (True) or disables (False) the File Transfer
Protocol (FTP) for transferring files rapidly between the
workstation and the switch. The default is True.
MgmtServerEnabled Enables (True) or disables (False) the management of
the switch through third-party applications that use GS-3
Management Server (MS). This parameter is the master
control for the Set Config Port command parameter,
MSEnable. The default is False.
Table B-24. Switch Services Settings (Continued)
Entry Description