Installation guide

B – Command Line Interface
Set Setup Command
59042-08 A B-83
0
Examples The following is an example of the Set Setup RADIUS command:
SANbox2 (admin) #> set setup radius
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the attributes
for the server being processed, press 'q' or 'Q' and the ENTER key to do so.
If you wish to terminate the configuration process completely, press 'qq' or
'QQ' and the ENTER key to so do.
DeviceAuthOrder (1=Local, 2=Radius, 3=RadiusLocal) [Local]
UserAuthOrder (1=Local, 2=Radius, 3=RadiusLocal) [Local]
TotalServers (decimal value, 0-5) [1 ]
Server: 1
ServerIPAddress (dot-notated IP Address) [10.20.11.8]
ServerUDPPort (decimal value) [1812 ]
LocalLogEnabled Enables (True) or disables (False) the saving of log
information on the switch. The default is True.
RemoteLogEnabled Enables (True) or disables (False) the recording of the
switch event log on a remote host that supports the
syslog protocol. The default is False.
RemoteLogHostAddress The IP address of the host that will receive the switch
event log information if remote logging is enabled. The
default is 10.0.0.254.
NTPClientEnabled Enables (True) or disables (False) the Network Time
Protocol (NTP) client on the switch. This client enables
the switch to synchronize its time with an NTP server.
This feature supports NTP version 4 and is compatible
with version 3. An Ethernet connection to the server is
required and you must first set an initial time and date
on the switch. The synchronized time becomes
effective immediately. The default is False.
NTPServerAddress The IP address of the NTP server from which the NTP
client acquires the time and date. The default is
10.0.0.254.
EmbeddedGUIEnabled Enables (True) or disables (False) the SANsurfer
Switch Manager Web applet. Changing this parameter
to False while the applet is running will terminate the
applet. The default is True.
Table B-26. System Configuration Settings (Continued)
Entry Description