Installation guide

B – Command Line Interface
Set Setup Command
B-84 59042-08 A
0
DeviceAuthServer (True / False) [True ]
UserAuthServer (True / False) [True ]
AccountingServer (True / False) [False ]
Timeout (decimal value, 10-30 secs) [10 ]
Retries (decimal value, 1-3, 0=None) [0 ]
SignPackets (True / False) [False ]
Secret (32 hex or 16 ASCII char value) [******** ]
Do you want to save and activate this radius setup? (y/n): [n]
The following is an example of the Set Setup Services command:
SANbox2 (admin) #> set setup services
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
*Warning: If services are disabled, the connection to the switch may be lost.
TelnetEnabled (True / False) [True ]
SSHEnabled (True / False) [False]
GUIMgmtEnabled (True / False) [True ]
SSLMgmtEnabled (True / False) [False]
EmbeddedGUIEnabled (True / False) [True ]
SNMPEnabled (True / False) [True ]
NTPEnabled (True / False) [False]
CIMEnabled (True / False) [True ]
FTPEnabled (True / False) [True ]
MgmtServerEnabled (True / False) [True ]
Do you want to save and activate this services setup? (y/n): [n]