Manual

[phone] www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
112
set {ip dscp <new-dscp> | ip precedence
<new-precedence> | cos <new-cos> | c-vid
<new-c-vid> | s-vid <new-s-vid> | s-tpid
<new-s-tpid>}
no set {ip dscp | ip precedence | cos | c-vid
| s-vid | s-tpid}
Assign a new DSCP, CoS and IP Precedence
value for the classified flow, no command
cancels the operation.
Single bucket mode:
policy <bits_per_second>
<normal_burst_bytes> ({action ACTION} |
exceed-action drop | transmit})
Dual bucket mode:
policy <bits_per_second>
<normal_burst_bytes> [pir
<peak_rate_bps>] |
<maximum_burst_bytes> [{action ACTION
| violate-action drop | transmit}]
ACTION definition:
policied-cos-to-cos-transmit | policied-cos-
to-dscp-transmit | policied-dscp-exp-to-
cos-transmit | policied-dscp-exp-to-dscp-
transmit
no policy
Configure a policy for the classified flow. The
non-aggregation policy command supports
three colors. Analyze the working mode of the
token bucket, whether it is single rate single
bucket, single rate dual bucket or dual rate
dual bucket, set corresponding action to
different color packets. The no command will
delete the configuration. Only specific switch
supports single bucket mode.
accounting
no accounting
Set statistic function for the classified flow.
After enable this function under the policy
class map mode, add statistic function to the
flow of the policy class map. In single bucket
mode, packets can only red or green when
passing policy. In the print information, in-
profile means green and out-profile means
red. In dual bucket mode, there are three
colors of packets in-profile means green and
out-profile means red and yellow.
3. Apply policy to port or VLAN
Command
Explanation
Interface Mode
service-policy output <policy-map-name>
Apply a policy map to the egress of the port;