Manual

[phone] www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
127
(1) Configure DAD neighbor solicitation message number
(2) Configure send neighbor solicitation message interval
(3) Enable and disable router advertisement
(4) Configure router lifespan
(5) Configure router advertisement minimum interval
(6) Configure router advertisement maximum interval
(7) Configure prefix advertisement parameters
(8) Configure static IPv6 neighbor entries
(9) Delete all entries in IPv6 neighbor table
(10) Set the hoplimit of sending router advertisement
(11) Set the mtu of sending router advertisement
(12) Set the reachable-time of sending router advertisement
(13) Set the retrans-timer of sending router advertisement
(14) Set the flag representing whether information other than the address information will be
obtained via DHCPv6
(15) Set the flag representing whether the address information will be obtained via DHCPv6
3. IPv6 Tunnel configuration
(1) Create/Delete Tunnel
(2) Configure tunnel description
(3) Configure Tunnel Source
(4) Configure Tunnel Destination
(5) Configure Tunnel Next-Hop
(6) Configure Tunnel Mode
(7) Configure Tunnel Routing
1. IPv6 Basic Configuration
(1) Configure interface IPv6 address
Command
Explanation
Interface Configuration Mode
ipv6 address <ipv6-address/prefix-
length> [eui-64]
no ipv6 address <ipv6-address/prefix-
length>
Configure IPv6 address, including aggregatable
global unicast addresses, site-local addresses and
link-local addresses. The no ipv6 address <ipv6-
address/prefix-length> command cancels IPv6
address.