Manual

[phone] www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
208
ip pim scope-border <1-
99 >|<acl_name>
no ip pim scope-border
To configure PIM-DM management boundary for the
interface and apply ACL for the management boundary.
With default settings, 239.0.0.0/8 is considered as the
scope of the management group. If ACL is configured,
then the scope specified by ACL permit command is the
scope of the management group. The no form of this
command will remove the configuration.
4. Disable PIM-DM protocol
Command
Explanation
Interface Configuration Mode
no ip pim dense-mode
To disable the PIM-DM protocol for the interface.
Global Configuration Mode
no ip pim multicast-routing
To disable PIM-DM globally.
28.2.3 PIM-DM Configuration Examples
As shown in the following figure, add the Ethernet interfaces of Switch A and Switch B to
corresponding vlan, and enable PIM-DM Protocol on each vlan interface.
PIM-DM Typical Environment
The configuration procedure for SwitchA and SwitchB is as follows:
(1) Configure SwitchA:
Switch(config)#ip pim multicast-routing
Switch(config)#interface vlan 1
Switch(Config-if-Vlan1)# ip address 10.1.1.1 255.255.255.0
Switch(Config-if-Vlan1)# ip pim dense-mode
Switch(Config-if-Vlan1)#exit
Switch(config)#interface vlan2
Switch(Config-if-Vlan2)# ip address 12.1.1.1 255.255.255.0
Switch(Config-if-Vlan2)# ip pim dense-mode
(2) Configure SwitchB:
SwitchA
SwitchB
Vlan 2
Vlan 1
Vlan 2
Vlan 1