Manual

[phone] www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
213
Configure the interface as the boundary interface of the PIM-SM protocol
Command
Explanation
Interface Configuration Mode
ip pim bsr-border
no ip pim bsr-border
To configure the interface as the boundary of PIM-
SM protocol. On the boundary interface, BSR
messages will not be sent or received. The network
connected the interface is considered as directly
connected network. The no form of this command
will remove the configuration.
Configure the interface as the management boundary of the PIM-SM protocol
Command
Explanation
Interface Configuration Mode
ip pim scope-border <1-99 > |
<acl_name>
no ip pim scope-border
To configure PIM-SM management boundary for
the interface and apply ACL for the management
boundary. With default settings, 239.0.0.0/8 is
considered as the scope of the management group.
If ACL is configured, then the scope specified by
ACL permit command is the scope of the
management group. acl_name should be standard
IPv4 ACL name. The no form of this command will
remove the configuration.
Configure global PIM-SM parameter
1) Configure the switch as a candidate BSR
Command
Explanation
Global Configuration Mode
ip pim bsr-candidate {vlan <vlan-id>|
<ifname>}[ <mask-
length>][ <priority> ]
no ip pim bsr-candidate
This command is the global candidate BSR
configuration command, which is used to configure
the information of PIM-SM candidate BSR so that it
can compete for BSR router with other candidate
BSR. The “no ip pim bsr-candidate” command
cancels the configuration of BSR.
2) Configure the switch as a candidate RP
Command
Explanation
Global Configuration Mode
ip pim rp-candidate { vlan <vlan-id>|
lookback<index> <ifname>}
This command is the global candidate RP
configuration command, which is used to configure