Manual

[phone] www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
214
[<A.B.C.D>][<priority>]
no ip pim rp-candiate
the information of PIM-SM candidate RP so that it
can compete for RP router with other candidate RP.
The “no ip pim rp-candidate” command cancels
the configuration of RP.
3) Configure static RP
Command
Explanation
Global Configuration Mode
ip pim rp-address <A.B.C.D>
[<A.B.C.D/M>]
no ip pim rp-address <A.B.C.D>
{<all>|<A.B.C.D/M>}
The command is the multicast group configuration
static RP of the globally or multicast address range.
The no form of this command will remove the
configuration for the static RP.
4) Configure the cache time of kernel multicast route
Command
Explanation
Global Configuration Mode
ip multicast unresolved-cache aging-
time <value>
no ip multicast unresolved-cache
aging-time
Configure the cache time of kernel multicast route,
the no command restores the default value.
4. Disable PIM-SM Protocol
Command
Explanation
Interface Configuration Mode
no ip pim sparse-mode | no ip pim
multicast-routing(Global
configuration mode)
To disable the PIM-SM protocol.
28.3.3 PIM-SM Configuration Examples
As shown in the following figure, add the Ethernet interfaces of SwitchA, SwitchB, SwitchC and
SwitchD to corresponding VLAN, and enable PIM-SM Protocol on each VLAN interface.
SwitchA
SwitchB
Vlan 1
Vlan 1
Vlan 2
rp
Vlan 2
Vlan 2
Vlan 2
bsr
Vlan 1
Vlan 1
Vlan 3
Vlan 3
SwitchD
SwitchC