Manual

[phone] www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
285
Configure MLD auxiliary parameters (Required)
(1) Configure MLD group parameters
1) Configure MLD group filter conditions
(2) Configure MLD query parameters
1) Configure the interval of MLD sending query message
2) Configure the maximum response time of MLD query
3) Configure overtime of MLD query
Shut down MLD Protocol
Start MLD Protocol
There is no special command for starting MLD Protocol on EDGECORE series layer 3
switches. MLD Protocol will automatically start up as long as any IPv6 multicast protocol is
started on corresponding interface.
Command
Explanation
Global Mode
ipv6 pim multicast-routing
To start Global IPv6 Multicast Protocol, the
precondition of starting MLD Protocol. The NO
operation of corresponding command shuts ipv6
multicast protocol and MLD Protocol. (Required)
Command
Explanation
Port Configuration Mode
ipv6 pim dense-mode | ipv6 pim
sparse-mode
Start MLD Protocol. The NO operation of
corresponding command shuts MLD Protocol.
(Required)
Configure MLD auxiliary parameters
(1) Configure MLD group parameters
Configure MLD group filter conditions
Command
Explanation
Port Configuration Mode
ipv6 mld access-group <acl_name>
no ipv6 mld access-group
Configure the filter conditions of interface for MLD
group; the NO operation of this command cancels
filter conditions.
(2) Configure MLD Query parameters
1) Configure interval time for MLD to send query messages
2) Configure the maximum response time of MLD query
3) Configure the overtime of MLD query