Manual

[phone] www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
286
Command
Explanation
Port Configuration Mode
ipv6 mld query-interval <time_val>
no ipv6 mld query-interval
Configure the interval of MLD query messages sent
periodically; the NO operation of this command
restores the default value.
ipv6 mld query-max-response-time
<time_val>
no ipv6 mld query-max-response-time
Configure the maximum response time of the
interface for MLD query; the NO operation of this
command restores the default value.
ipv6 mld query-timeout <time_val>
no ipv6 mld query-timeout
Configure the overtime of the interface for MLD
query; the NO operation of this command restores
the default value.
Shut down MLD Protocol
Command
Explanation
Port Configuration Mode
no ipv6 pim dense-mode | no ipv6 pim
sparse-mode | no ipv6 pim multicast-
routing (Global Mode)
Shut down MLD Protocol
29.6.3 MLD Typical Application
As shown in the following figure, add the Ethernet interfaces of Switch A and Switch B to
corresponding vlan, and start PIM6 on each vlan interface.
Network Topology Diagram
The configuration procedure for SwitchA and SwitchB is as below:
(1) Configure SwitchA:
Switch (config) #ipv6 pim multicast-routing
Switch (config) #ipv6 pim rp-address 3FFE::1
Switch (config) #interface vlan 1
Switch (Config-if-Vlan1) #ipv6 address 3FFE::1/64
Switch (Config-if-Vlan1) #ipv6 pim sparse-mode
(2) Configure SwitchB:
SwitchB
Vlan 1
Vlan 1
Vlan 2
SwitchA