Manual

[phone] www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
80
<value>
port-security maximum” command restores
the default value.
switchport port-security violation {protect |
shutdown} [recovery <30-3600>]
no switchport port-security violation
Set the violation mode for the port; the “no
switchport port-security violation”
command restores the default setting.
4. mac-notification trap configuration
Command
Explanation
Global Mode
mac-address-table periodic-monitor-time
<5-86400>
Set the MAC monitor interval to count the
added and deleted MAC in time, and send out
them with trap message.
10.5.1.3 Binding MAC Address Binding Troubleshooting
Enabling MAC address binding for ports may fail in some occasions. Here are some possible
causes and solutions:
If MAC address binding cannot be enabled for a port, make sure the port is not enabling port
aggregation and is not configured as a Trunk port. MAC address binding is exclusive to such
configurations. If MAC address binding is to be enabled, the functions mentioned above must
be disabled first.
If a secure address is set as static address and deleted, that secure address will be unusable
even though it exists. For this reason, it is recommended to avoid static address for ports
enabling MAC address.