Installation guide

Quadro Manual I: Installation Guide Step 2: Configuring the Quadro
Quadro2x, 2xi, Quadro4x, 4xi, 4xa, Quadro16x, 16xi; (SW Version 4.1.x) 34
Step 2-A: Using IP Lines
The basic configuration procedure for Quadro IP PBXs that use IP lines is exactly the same
as described in Step 2.
Before starting the IP Lines specific configuration, the appropriate IP Phone (the list of SIP
phones supported by Quadro is presented below) should be connected to the LAN port of
the Quadro.
Each IP line should be configured individually from the Telephony menu, Line Settings
page, IP Line Settings tab.
Fig. I-32: Line Settings page
Click on the IP Line number to enter the IP Lines Settings page.
Fig. I-33: IP Line Settings page
Select the SIP Phone radio button. Select the SIP IP phone model from the Phone Model
drop down list.
Insert the SIP Phone’s MAC address in the corresponding fields. The MAC address of an
IP phone is usually printed on the back of the phone’s base unit.