Installation guide

Quadro Manual I: Installation Guide Step 2: Configuring the Quadro
Quadro2x, 2xi, Quadro4x, 4xi, 4xa, Quadro16x, 16xi; (SW Version 4.1.x) 37
Step 2-B: Using Receptionist
If you wish to use the Receptionist’s features, the Receptionist should be set up on the
Quadro. The Quadro’s basic configuration should be done in the same way as described in
the Step 2.
The Receptionist related setup, with detailed instructions on how to configure the Quadro
and the attached IP Phones, is described in the “Receptionist Setup on Quadro” docu-
ment, which you can find at the Epygi’s Support Web portal.
Step 2-C: Using ISDN Lines
The basic configuration procedure for Quadro IP PBXs that use ISDN lines is exactly the
same as described in Step 2.
As some ISDN providers require an outgoing MSN to be defined, go to the Telephony
menu and open the ISDN Settings page.
The number of available ISDN trunks is dependent on the type of your Quadro. Quadro2xi
and Quadro4xi have only one ISDN trunk available. Quadro16xi and the special edition of
Quadro4xi have 3 ISDN trunks available.
Fig. I-34: ISDN Trunk Settings page
Before starting the ISDN Trunk configuration, please consult with your ISDN provider ad-
ministrator to receive instructions for which settings are necessary to be configured.
For each of the trunks in the ISDN Trunks table in Fig.I-32, the following configuration
should be performed. Edit trunk settings by selecting the appropriate trunk from the list and
pressing Edit functional button from the ISDN Trunk Settings page toolbar.
Fig. I-35: ISDN Trunk - Edit page
The Coding Type, LoopBackMode and Passive Mode settings in the Trunk # - Edit En-
try page should be set according to your ISDN provider requirements.
Run the ISDN Wizard for each ISDN trunk to make sure that all settings are proper. To ac-
cess ISDN Wizard, select the appropriate trunk from the list and press the Settings func-
tional button from the ISDN Trunk Settings page toolbar.