Installation guide

Quadro Manual I: Installation Guide Step 2: Configuring the Quadro
Quadro2x, 2xi, Quadro4x, 4xi, 4xa, Quadro16x, 16xi; (SW Version 4.1.x) 38
DDI (Device Dialing Inward) service and TEI mode can be selected from the first page of
the ISDN Wizard.
Fig. I-36: ISDN Wizard – Page 1
Leave DDI Service disabled if you wish to use MSN services (i.e. if you have more than
one ISDN number provided by the Central Office). Configure TEI mode according to ISDN
provider requirements.
Clicking Next will refer to the ISDN Wizard page where MSN Settings can be configured.
Fig. I-37: ISDN Wizard – Page 2
If you left DDI Service disabled, this page will offer you the choice of using MSN services
or not.
If you have one ISDN number assigned to the corresponding ISDN trunk, select the No
other devices are connected to ISDN bus radio button and define the destination where
to route the incoming calls.
If you have more than one ISDN numbers provided by the Central Office, select the Other
devices are connected to ISDN bus radio button. This selection will require you to config-
ure the MSN Table after finishing the ISDN Wizard. The MSN table can be accessed from
the table on the ISDN Trunk Settings page, by pressing the MSN Service link for the cor-
responding trunk.