Installation guide

Quadro Manual I: Installation Guide Step 3: Registering on Epygi’s Technical Support
Quadro2x, 2xi, Quadro4x, 4xi, 4xa, Quadro16x, 16xi; (SW Version 4.1.x) 40
Step 2-D: Using an ADSL or G.SHDSL Uplink
If a Quadro IP PBX with ADSL or G.SHDSL uplink is used, the basic configuration of the
WAN interface differs slightly from the procedure in Step2.3: Uplink Configuration,
Step2.3: PPP/PPTP Configuration and Step2.3: WAN Interface Configuration. Each
procedure has additional ADSL or G.SHDSL uplink interface specific components.
Uplink Configuration Page
This page offers the PPPoA, 1483R or 1483B WAN Interface Protocols to be selected:
Fig. I-39: Internet Configuration Wizard - Uplink Configuration page for Quadro IP PBXs with ADSL Uplink
Enter the values recommended by your ADSL or G.SHDSL provider for the WAN Interface
Bandwidth.
PPP/PPTP Configuration
Enter the IP address of the PPTP server into the PPTP Server text field.
Choose the encryption for the traffic over the PPTP interface from the Encryption drop
down list.
Authentication Settings require the Username and the Password used for the authentica-
tion on the ISP server.
Dial Behavior radio buttons:
• Dial Manually - if this radio button is activated, a button will be displayed in the main
management window that serves to switch the Internet connection on/off. When ac-
cessing the Internet, every station of the connected LAN has to connect to Quadro
first.
• Always connected – if this radio button is activated, Quadro stays in the always con-
nected mode. This will allow Quadro remain always online in the network.
The IP Address Assignment field is used to specify the external IP address given to the
Quadro. Usually it is a dynamic address but in some cases you may be given a static IP
address.