Installation guide

Quadro Manual I: Installation Guide Step 3: Registering on Epygi’s Technical Support
Quadro2x, 2xi, Quadro4x, 4xi, 4xa, Quadro16x, 16xi; (SW Version 4.1.x) 41
Fig. I-40: PPP/PPTP Configuration page
If your ISP assigns a dynamic IP address, activate the Dynamic IP Address radio button.
Otherwise activate the Fixed IP Address radio button and enter the IP address you were
assigned by your ISP.
PPPoA specific selection is used to choose between manual or default ADSL or G.SHDSL
connection parameters. For Default selection, the preconfigured parameter set can be se-
lected from the list. For Manual selection, VPI, VCI and Encapsulation parameters should
be specified manually. Configure the corresponding settings according to you ISP adminis-
trator’s requirements.
Keep Connection alive checkbox enables keeping the connection alive by sending control
packets dedicated for the link state verification.
Click the Next button to display the WAN Interface Configuration page.