Installation guide
Quadro Manual I: Installation Guide Appendix: Registering on Epygi SIP Server
Quadro2x, 2xi, Quadro4x, 4xi, 4xa, Quadro16x, 16xi; (SW Version 4.1.x) 54
Fig. I-55: Extensions Management - Edit Entry – SIP Settings page
• Enter the SIP registration number displayed in the column Ext# into the text field Reg-
istration User Name.
• In the Password field, enter the password you specified when registering at the SIP
server and confirm it in the field below.
• In Registration SIP Server, the selected SIP server address must be entered. If you
use the Epygi SIP server, you may leave the default entry sip.epygi.com.
• Most SIP server providers, including Epygi, use port 5060 as the Registration SIP
Port. You may leave the default entry as is.
• Select Registration on SIP Server if you want to establish and receive IP calls.
• Click the Save button to activate the settings.
Other settings of the extension might be also modified from Extensions Management –
Edit Entry page (refer to the Manual II - Administrator’s Guide).
Your settings will be verified, then after a few seconds the Extensions Management page
is updated with the changes as shown in the below example, Fig.I-56.
Fig. I-56: Extensions Management page
If you go back to Epygi’s SIP Server, you will find the value reg. for this number in the col-
umn Stat. Reg. This will indicate that the Quadro has successfully registered the new num-
ber. If this does not happen after a few minutes, again verify the SIP Number and pass-
words.