User Manual

SAFETY DATA SHEET
According to the Hazardous Products Regulations
Quaker State Ultimate Durability SAE 5W-30
Full Synthetic Motor Oil
Version
1.2
Revision Date:
2016-04-28
SDS Number:
800001028740
Print Date: 2016-04-29
Date of last issue: 07.04.2016
Date of first issue: 12.03.2013
6 / 14 800001028740
CA
Where material is heated, sprayed or mist formed, there is
greater potential for airborne concentrations to be generated.
General Information:
Define procedures for safe handling and maintenance of
controls.
Educate and train workers in the hazards and control
measures relevant to normal activities associated with this
product.
Ensure appropriate selection, testing and maintenance of
equipment used to control exposure, e.g. personal protective
equipment, local exhaust ventilation.
Drain down system prior to equipment break-in or mainte-
nance.
Retain drain downs in sealed storage pending disposal or
subsequent recycle.
Always observe good personal hygiene measures, such as
washing hands after handling the material and before eating,
drinking, and/or smoking. Routinely wash work clothing and
protective equipment to remove contaminants. Discard con-
taminated clothing and footwear that cannot be cleaned.
Practice good housekeeping.
Personal protective equipment
Respiratory protection : No respiratory protection is ordinarily required under normal
conditions of use.
In accordance with good industrial hygiene practices, precau-
tions should be taken to avoid breathing of material.
If engineering controls do not maintain airborne concentra-
tions to a level which is adequate to protect worker health,
select respiratory protection equipment suitable for the spe-
cific conditions of use and meeting relevant legislation.
Check with respiratory protective equipment suppliers.
Where air-filtering respirators are suitable, select an appro-
priate combination of mask and filter.
Select a filter suitable for the combination of organic gases
and vapours [Type A/Type P boiling point >65°C (149°F)].
Hand protection
Remarks : Where hand contact with the product may occur the use of
gloves approved to relevant standards (e.g. Europe: EN374,
US: F739) made from the following materials may provide
suitable chemical protection. PVC, neoprene or nitrile rubber
gloves Suitability and durability of a glove is dependent on
usage, e.g. frequency and duration of contact, chemical re-
sistance of glove material, dexterity. Always seek advice from
glove suppliers. Contaminated gloves should be replaced.
Personal hygiene is a key element of effective hand care.
Gloves must only be worn on clean hands. After using
gloves, hands should be washed and dried thoroughly. Appli-