Installation Guide

ManualsBrandsQualGear ManualsElectricalUniversal Ultra Slim Fixed Wall Mount for most 32 in. - 55 in. TVs, Black [UL Listed]

CAUTION!

Do not exceed the maximum rated weight

specified. Otherwise, serious injury or

property damage may occur.

Version: July 2023Version: July 2023

100x100 100x150 100x200 150x100 150x150

200x100 200x200 300x200 300x300 400x200

400x300 400x400

35kg

(77lbs)

RATED

1-Year Limited Warranty1-Year Limited Warranty

To detach the TV assembly from the wall

plate, using an assistant, pull the cords at the

bottom of the brackets, and tilt the TV up to

snap out of the brackets, then lift the TV to

detach it from the wall plate.

Detach the TV

Summary of content (6 pages)

PAGE 1
5 Detach the TV To detach the TV assembly from the wall plate, using an assistant, pull the cords at the bottom of the brackets, and tilt the TV up to snap out of the brackets, then lift the TV to detach it from the wall plate. CAUTION! 35kg (77lbs) RATED Do not exceed the maximum rated weight specified. Otherwise, serious injury or property damage may occur.
PAGE 2
NOTE Please read the entire installation manual before you start installation and assembly. WARNING Do not begin to install your QualGear product until you have read and understood all the instructions and warnings contained in this installation manual. If you have any questions regarding the instructions, for US customers please contact QualGear customer support via email at support@qualgear.com. For all international customers, please contact your local distributor.
PAGE 3
1a Mounting to a Wooden Stud Wall For concrete wall NOTE mounting, follow Step 1b. Stud Finder W-C 1 2 . Using an edge-to-edge stud finder, find the edges of the stud. W-A Using a level, mark the centerline of the stud 55mm (2 (2.. 2") ø 4.5mm (ø 3/16") B Wall Plate 5 Mount the wall plate (B) and tighten it with the provided lag bolts (W-A) and D6 washers (W-C) using a socket wrench. 3 4 D TIP 3 Do NOT use power drill and do NOT over tighten the lag bolts.
PAGE 4
1b Mounting to a Concrete or Brick Wall Do NOT use power drill and do NOT over tighten the lag bolts. NOTE W-C W-B B Wall Plate W-A 1 D Marking Template Hold the marking template (D) provided against the wall where you want to install your TV, mark four holes for drilling. TIP Choose two holes on each side. Then, mark four holes on the wall using thetemplate provided. B 60mm 0mm (2.4") (2. ") Wall Plate ø 10mm (ø 3/8") 3 Place concrete anchors (W-B) in each hole.
PAGE 5
2 Attach TV Brackets Choose the appropriate screws and washers according to the type of your TV, and attach adapter brackets (A) to the back of the TV using a Phillips screwdriver. IMPORTANT! Tighten all screws but do NOT over tighten A TIP Use a toothpick to measure the depth of the mounting hole and choose the appropriate mounting screws.
PAGE 6
3 Hang the TV 4 Level the TV Once the brackets are attached to the TV, using an assistant, place the brackets on the wall plate securely. While holding the TV assembly securely, pull the cords at the bottom of the brackets and push the TV assembly to snap on the wall plate firmly. After the TV is placed on the wall plate securely, check the level of the TV to ensure that it is perfectly level.