Reference Guide

Chapter 4 SCSI Commands
LOG SENSE Command (4Dh)
DLT-S4 Interface Reference Guide 87
31 Hardware B C The tape drive has a hardware fault:
1. Turn the tape drive off and then on again.
2. Restart the operation.
3. If the problem persists, call the tape drive supplier helpline.
Check the tape drive users manual for device specific instructions
on turning the device power on and off.
32 Interface W The tape drive has a problem with the host interface:
1. Check the cables and cable connections.
2. Restart the operation.
34 Download Fail W The firmware download has failed because you have tried to use the
incorrect firmware for this tape drive.
Obtain the correct firmware and try again.
36 Drive
Temperature
W Environmental conditions inside the tape drive are outside the
specified temperature range.
38 Predictive
Failure
C A hardware failure of the tape drive is predicted. Call the tape drive
supplier helpline.
40 Loader
Hardware A
C The changer mechanism is having difficulty communicating with
the tape drive:
1. Turn the autoloader off then on.
2. Restart the operation.
3. If problem persists, call the tape drive supplier helpline.
42 Loader
Hardware B
W There is a problem with the autoloader mechanism.
51 Tape directory
invalid at
unload
W The tape directory on the tape cartridge just unloaded has been
corrupted.
File search performance will be degraded. The tape directory can be
rebuilt by reading all the data.
55 Loading
Failure
C The operation has failed because the media cannot be loaded and
threaded.
1. Remove the cartridge, inspect it as specified in the product
manual, and retry the operation.
2. If the problem persists, call the tape drive supplier help line.
Flag
Security
Level Description