Reference Guide

Chapter 4 SCSI Commands
LOG SENSE Command (4Dh)
DLT-S4 Interface Reference Guide 95
Parameter
Code
(continued)
0005h Drive temperature in degrees C.
0006h Media ID of the most recently loaded cartridge.
0007h Controller serial number (least significant 16 bits). The drive uses this
value to generate the Media ID for blank tape cartridges.
0008h Drive cleaning cycle count.
0009h Serial number of the first drive to write the current tape.
000Ah Serial number of the last drive to write the current tape.
000Bh Total number of event log entries that are available through log page
07h.
000Ch Maximum number of parameter codes per event log entry in log page
07h.
000Dh Maximum number of cleans on a cleaning cartridge.
000Eh Number of drive power cycles.
000Fh Power on time for this power cycle, in milliseconds.
0010h Total drive power on time, in milliseconds.
0011h Current Track Number.
7000h TapeAlert flags bit map — See ADC specification INCITS 403-2005,
Table 17 - bytes 4-15.
8000h Drive Lifetime media loads
8001h Drive Lifetime media motion hours
8002h Drive media motion hours since last clean
8003h Periodic Cleaning Interval in media motion hours
8004h Drive Lifetime GBs written to tape
8005h Drive Lifetime GBs read from tape
9000h Media Lifetime load count
9001h Media Lifetime load count threshold
9002h Media Lifetime wear passes
9003h Media Lifetime wear passes threshold
9004h Media Lifetime motion hours
9005h Media Lifetime motion hours threshold
Parameter
Control Byte
Bit Value Description
DU 0 Disable Update.
Field Description