Reference Guide

Chapter 4 SCSI Commands
LOG SENSE Command (4Dh)
DLT-S4 Interface Reference Guide 96
Figure 48 Cleaning-Related
Log Parameters Format for
Device Status LOG SENSE
Page
DS 1 Disable Save.
TSD any Target Save Disable. When set to zero indicates the parameter is saved
periodically. When set to one the parameter is not saved.
ETC 0 Enable Threshold Comparison.
TMC 0 Threshold Met Criteria.
LBIN any List Binary. When set to zero indicates the parameter value is in ASCII.
When set to one, indicates the parameter value is a binary number.
LP any List Parameter. When set o zero indicates the parameter value is a
counter. When set to one, indicates the parameter value is not a counter.
Parameter
Length
Specifies the number of bytes in the parameter value.
Parameter
Value
Indicates the actual value of this log parameter.
Bit
Byte
7 6 5 4 3 2 1 0
4 Reserved ClnQ ClnR ClnEx
5 — 7
(MSB)
Reserved
(LSB)
Field Description