- Two Channel Low Profile RS-232 Asynchronous Communications Adapter User Manual

3 Hardware Installation

1. Turn off the power of the computer system in which the DSCLP-100 is to be

installed.

2. Remove the system cover according to the instructions provided by the

computer manufacturer.

3. Make any desired optional jumper setting changes.

4. Install the DSCLP-100 in any empty PCI expansion slot. The board should be

secured by installing the Option Retaining Bracket (ORB) screw.

5. Replace the system cover according to the instructions provided by the

computer manufacturer.

6. Attach and secure the cable connectors to the desired equipment.

7. Turn on the power of the computer system.

The output of the DSCLP-100 is a 25-pin D-connector. A cable is provided

to convert the D-25 into two standard male D-9 connectors with all control signals

provided to each port (RTS, DTR, CTS, DSR, DCD, and RI).

SPAD

Clock multiplier/

scratchpad select

Figure 5 --- Jumper/connector locations

4 DSCLP/SSCLP-100 User's Manual