User's Manual PCMCIA Asynchronous Adapter MPAP-100

The enabler requires a single desired configuration to be provided on the command line.
The card will not be configured if the desired configuration is not provided. The desired
configuration must be enclosed in parentheses and it contains parameters separated using
commas (no spaces). In the descriptions below, replace the '#' symbols with the appropriate
numeric values.
MPAP1EN (S#,B#,I#,W#,C)
S# The PCMCIA socket into which the MPAP-100 will be inserted. This value is a
decimal number ranging from 0 to 15. This parameter is always required when
configuring a card.
B# The base I/O address of the MPAP-100. This number must be a three-digit
hexadecimal value ending in 0. This parameter is always required when
configuring a card.
I# The interrupt level (IRQ) of the MPAP-100. This decimal number must be one of
the following values: 3, 4, 5, 7, 9, 10, 11, 12, 14, 15, or 0 if no IRQ is desired.
This parameter is always required when configuring a card.
W# (optional) The base address of the memory window used by the enabler. This
two-digit hexadecimal number can be one of the following values: C8, CC, D0
(default), D4, D8, or DC. Use D4 for a memory window at segment D400, D8 for
a memory window at segment D800, etc. If this parameter is omitted, the default
setting of D000 will be used.
C (optional) Drive SYNC input of SCC channel A with the Remote Loopback bit of
Communications Register (see page 39). If this parameter is omitted, the SYNC
input of SCC channel A will be undefined.