User`s manual

4 Other Operating Systems

Device drivers for Windows NT and OS/2 are also available for the MPAC-100.

The board can be used under DOS and other operating systems as well in many

circumstances. The software described below can be downloaded from the Quatech

web site if it did not come with the board.

4.1 Windows NT

The Windows NT device driver is installed by running the SETUP program. Up

to 256 serial ports are supported. There is a command line-based configuration utility

which is used for adding PCI bus and ISA bus serial ports. Please refer to the

documentation included with the device driver for full installation and configuration

details.

4.2 OS/2

The OS/2 device driver supports up to 32 serial ports in a system. Installation is

a manual, but simple, process. Please refer to the documentation included with the

device driver for full installation and configuration details.

4.3 DOS and other operating systems

The MPAC-100 is not a direct drop-in replacement for a legacy serial port

because its base address and IRQ cannot be fixed at values such as 3F8 hex, IRQ 4

(COM1) or 2F8 hex, IRQ 3 (COM2), etc. Rather, the system BIOS assigns the address

and the IRQ in a plug-and-play fashion at boot time. Software which is to use the

MPAC-100 must be able to accommodate any valid assignments of these resources.

For Windows 95, Windows NT and OS/2, the Quatech device drivers determine

what the resource assignments are and proceed accordingly. In other cases, however,

the user must intervene. The discussion below will center on DOS, but the concepts

can be applied to other operating systems as well.

Many DOS applications support user configuration of the base address and IRQ

of a serial port. Such applications can generally make use of the MPAC-100. Older

applications, as well as some custom software, may use hard-coded standard legacy

serial port addresses. These applications will require modifications if they are to use

the MPAC-100.

Custom applications for which the customer has source code can be modified to

make just a few PCI BIOS function calls to obtain all the necessary configuration

information. The PCI BIOS specification can be

obtained from the PCI Special Interest Group. Contact Quatech technical support for

more information.

4.4 QTPCI.EXE

Quatech MPAC-100 User's Manual