User`s manual

Quatech's "QTPCI" utility supplies the information required when modifying
the serial port settings of the application. This program should be run from real DOS,
not in a Windows DOS box.
Figure 13 shows the Basic Mode display for the MPAC-100 after the "Q" key has
been pressed. In this example, the MPAC-100 uses I/O base address FF80 hex and IRQ
11. The hardware revision of the MPAC-100 is also displayed. Pressing the "N" key
will show similar information for all non-Quatech PCI devices in the system, including
those devices integrated on the motherboard.
Quatech MPAC-100 User's Manual
15