User`s manual

42
14 FIFO Control Register
..........................................
41
13 FIFO Status Register
............................................
40
12 Interrupt Status Register
.......................................
38
11 Configuration Register
.........................................
36
10 Communications Register
......................................
35
9.7 Receive FIFO timeout
.......................................
34
9.6 Receive pattern detection
....................................
33
9.5 Accessing the SCC while FIFOs are enabled
................
33
9.4.4 Controlling the FIFOs
....................................
33
9.4.3 Reading current FIFO status
.............................
33
9.4.2 Resetting the FIFOs
......................................
32
9.4.1 Interrupt status
...........................................
32
9.4 FIFO status and control
......................................
31
9.3.2 Using channel B for receive
..............................
30
9.3.1 Using channel A for both transmit and
..........................................................
29
9.3 SCC configuration for FIFO operation
......................
29
9.2.2 Receive FIFO
.............................................
28
9.2.1 Transmit FIFO
............................................
28
9.2 Accessing the FIFOs
..........................................
28
9.1 Enabling and disabling the FIFOs
..........................
28
9 FIFO Operation
..................................................
27
8.5.2 Software Interrupt Acknowledge
........................
27
8.5.1 Register Pointer Bits
......................................
27
8.5 SCC Incompatibility Warnings
.............................
26
8.4.4 Other signals are not used
...............................
26
8.4.3 Extra handshaking for channel A
........................
26
8.4.2 Extra clock support for channel A
.......................
26
8.4.1 Receive data and clock signals
...........................
26
8.4 Support for SCC Channel B
................................
25
8.3 SCC Data Encoding Methods
...............................
25
8.2 Baud Rate Generator Programming
.........................
22
8.1 Accessing the registers
.......................................
21
8 SCC General Information
.......................................
20
7 Interrupts
.........................................................
19
6 Addressing
.......................................................
18
5 Using the MPAC-100 with Syncdrive
...........................
14
4 Other Operating Systems
........................................
9
3 Windows 95/98 Installation
......................................
8
2 Hardware Installation
............................................
7
1.1 System Requirements
.........................................
7
1 Introduction
......................................................
Table of Contents