User`s manual

15 Receive Pattern Character Register
The Receive Pattern Character Register is used to set the character value to be
used in receive pattern detection. The address of this register is Base+B (hex). This
register can be ignored if the internal FIFOs are not being used.
character value (0-255)
Bit 0
Bit 1
Bit 2
Bit 3
Bit 4
Bit 5
Bit 6
Bit 7
Table 14 --- Receive Pattern Character Register - Read/Write
Bits 7-0: Receive Pattern Character: This is
the numeric value of the character to be detected. See page 37 for details
on the receive character pattern detection feature.
Quatech MPAC-100 User's Manual
43