User`s manual

21 Specifications
Bus interface: PCI, 32-bit bus, 5 volt only
AMCC 5920 PCI Controller
Physical Dimensions: approx. 4.5” x 2.5”
Controller: Zilog Z85230 20-MHz Serial
Communications Controller (SCC)
DTE Interface: Male D-25 connector
5 volt fuse on pin 9
Transmit drivers: SP211HB RS-232 compatible,
600 kbps typical maximum data rate
Receive buffers: SP211HB RS-232 compatible,
600 kbps typical maximum data rate
I/O Address range: Sixteen-byte contiguous range required,
determined by PCI system
Interrupt levels: One IRQ required, determined by
PCI system
DMA channels: Not supported by PCI bus
Power requirements: 115 mA at +5 volts, typical
Quatech MPAC-100 User's Manual
54