Installation Guide

Quick Step Studio Laminate Flooring Installation Instructions
2
2020_0325_QS_LOW_INST
Site and Material Preparation
A) Remove carpet and padding. Also remove any wood flooring installed on concrete. Do not remove products
unless they are asbestos-free.
B) Undercut door frame and wallbase. Slide the flooring at least 1/4" underneath the door frame and wallbase.
Also leave a concealed 3/8" minimum expansion space under each.
C) Remove bumps or peaks in subfloor and fill depressions with floor leveling compound to ensure no more than
3/16" unevenness per 10-foot span.
D) Acclimate unopened product before installation. If there is no time for acclimation, there should be no more than
a difference of 25° F and 20% relative humidity between the stocking/transportation environment of the flooring
and the final installation environment of the flooring.
E) Clean debris from subfloor before installation.
F) For concrete subfloors, install vapor barrier with overlapped seams of 8" or more.
G) For planks without attached underlayment, install over single layer of underlayment appropriate for laminate
floors. For planks with attached underlayment, it is acceptable to install Pergo Gold
™
underlayment (Lowes
Part # 670312) prior to flooring installation if desired. Make sure to follow the Pergo Gold installation instructions,
taking special care to seal all foam edges with sealing tape and repair all rips and perforations in the underlayment
vapor barrier prior to flooring installation. A separate vapor barrier should not be used in conjunction with
Pergo Gold.
A
C
GF
D E
B
Door
Frame
Cutting Line
Wallbase
Casing
1 inch
(2,5 cm)
%
48 hours
60° – 85° F
15° – 29° C
35% – 65% RH
subfloor
6 mil (0.15 mm) virgin
polyethelene vapor barrier
> 8" (200 mm)