Product Manual

QT/QTS Series Quincy Compressor
50161-108, January 2013 4 3501 Wismann Lane, Quincy Ill. - 62305-3116
Oil and moisture residue must be drained from the air receiver
daily or after each use. Accumulations of oil residue in the receiver
can be ignited by embers of carbon created by the heat of compres-
sion, causing an explosion, damage to property and injury to per-
sonnel.
When using battery cables to start engine driven units do not use
more than a total of 40 ft. of #4 gauge cable (GND & HOT).
The owner, lessor or operator of any compressor unit manu factured by
Quincy Compressor is hereby warned that failure to ob serve the safety precau-
tions and procedures outlined in this manual may result in serious personal
injury, damage to property, and may void your warranty. Quincy Compressor
must authorize all warranty service. Before contacting your distributor or the
factory, check the maintenance requirements and the troubleshooting guide
for your compressor. Most warranty issues can be resolved by following proper
maintenance procedures.
Quincy Compressor neither states as fact, nor in any way implies that the
above list of safety precautions is an all inclusive list, the observance of which
will prevent all damage to property or injury to personnel.
Every effort has been taken to ensure that complete and correct instructions
have been included in this manual. However, possible product updates and
changes may have occurred since this printing. Quincy Compressor reserves
the right to change specifications with out incurring any obligation for equip-
ment previously or subse quently sold.
Summary of Changes to This Manual
(since previous printing dated December 2011):
· Removed warranty statement and added URL address on front cover for
warranty information available on the Quincy Compressor website.
· The wiring diagram for a single phase combination pressure switch /
overload relay wired to a 3600 RPM motor was added to this manual.
· Edited Electrical Supply Requirements to include Canadian Standards
Association (CSA) requirements.
· Added Air Tank Inspection information.
· Added QTS Series information.
WARNING !
CAUTION !