Installation Sheet

1of2
Assembly Instruction Sheet #IS-PCLA8532BN
For Style PCLA8532BN
Pleasegoto forproductcleaningtips.Gotothe selection.
IntegratedLED36W
30-45minutes
Identifyandinspectallpartsbeforebeginninginstallation.Checkpackagecontentlistanddiagramsbelowtobesureallpartsare
present.Ifanypartsaremissingordamaged,donotattempttoassemble,install,oroperatethefixture.Contactcustomerserviceforreplacement
parts.
www.quoizel.com Care+Maintenance
LightSource:
EstimatedAssemblyTime:
Preparation:
ToolsRequired:Flatheadscrewdriver, Phillips screwdriver,pliers,wirecutters,wirestrippers,electricaltape,safetyglasses.
CompatibleDimmerSwitches:LutronAYCL-153PorLutronDVCL-153P.
Warnings and Cautions
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Package Contents
Inner Backplate
x1
A
F
Fixture Body
x1
Mounting
Screw
x4
B
2017 QuoizelInc.
ReleasedDate:2017-09-26
Thank you for purchasing a Quoizel product.
Need assistance with parts or assembly? Call Quoizel customer service at 1-800-645-3184
or visit us on-line at www.quoizel.com
E
Glass Tube
x1
G
Glass Holder
x1
H
Lock Screw
x2
STEP 1 Install Glass Tube-
A. Slip the Glass Tube (F) into the Fixture Body (E). Attach the Glass Holder (G) onto the end of the Glass Tube (F) and secure with Lock
Screws (H). Hand tighten until snug with screwdrivers.
Figure 1
STEP 2 Install the Inner Backplate to the junction box-
A. Place the Inner Backplate (A) onto the wall surface and line up one
set of holes onto mounting holes on Outlet Box. Using a pencil,
mark the locations for Wall Anchors (C).
B. Remove the Inner Backplate (A) and drill holes from the marks on
the wall surface and then push the Wall Anchors (C) into the holes.
C. Race all supply wires and ground wire through the Inner Backplate
(A) as shown. Position the Inner Backplate (A) back onto the wall,
secure by threading the Outlet Box Screws (not supplied) into the
mounting holes on the Outlet Box and screw Self-tapping Screws
(D) into the Wall Anchors (C). Tighten until snug with screwdrivers.
Figure 2
STEP 3 - Wire Connections
A. Wrap bare or green ground wire around green ground screw on the
crossbar, no less than 2 inches from the end of the wire. Tighten the
green ground screw.
B. Use standard wire connectors (not included) to make all wire
connections. Twist connectors until wires are tightly joined together.
Wrap each connection with approved electrical tape and carefully
stuff all the connected wires into the Outlet Box.
Green Ground Screw
on the Crossbar
White wire
from outlet box
White wire
from fixture
Black wire from
outlet box (or Red)
Black wire
from fixture
Bare, or Green
Ground wire
from outlet box
Ground wire
from Fixture
Figure 3
Wall
Anchor
x2
C
Self-tapping
Screw
x2
D
E
F
G
H
Outlet Box Screw
(not supplied)
Supply Wires and
Ground Wire
A
Outlet Box
D
C