Installation Sheet

1of2
Assembly Instruction Sheet #IS-PCSK136C
For Style PCSK136C
Package Contents
B
Mounting Screw
x4
Inner Backplate
x1
A
2017 QuoizelInc.
ReleasedDate:2017-08-28
Warnings and Cautions
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Pleasegoto forproductcleaningtips.Gotothe selection.
Flatheadscrewdriver,Phillipsscrewdriver,pliers,wirecutters,wirestrippers,electricaltape,safetyglasses.
Integrated30WLED
:LutronAYCL-153Por Lutron DVCL-153P.
www.quoizel.com Care+Maintenance
ToolsRequired:
LightSource:
CompatibleDimmerSwitches
EstimatedAssembly Time:
Preparation:
20-30minutes
Identifyandinspectallpartsbeforebeginninginstallation.Checkpackagecontentlistanddiagramsbelowtobesureallpartsare
present.Ifanypartsaremissingordamaged,donotattempttoassemble,install,oroperatethefixture.Contactcustomerserviceforreplacement
parts.
Thank you for purchasing a Quoizel product.
Need assistance with parts or assembly? Call Quoizel customer service at 1-800-645-3184
or visit us on-line at www.quoizel.com
C
Fixture Body
x1
STEP 1 Install Inner Backplate-
A. Pass the supply wires and ground wire through the Inner Backplate
(A). Attach the Inner Backplate (A) to Outlet Box with the head of
Green Ground Screw facing you. Secure it with Outlet Box Screws
(not included). Tighten until snug.
A
Outlet Box
Outlet Box Screw
(not supplied)
Figure 1
Supply Wires and
Ground Wire
STEP 2 - Attach Lanyard
A. The purpose of the lanyard is to provide the installer a means to
support the fixture from the junction box while connecting the
electrical wires. This enables the fixture to hang from the junction
box and your hands are free to make the wire connections.
B. Turn the Button Stop so it may be inserted into the Inner Backplate
slot. Make sure the Button Stop is completely inside the Inner
Backplate (A). Slowly release the fixture to make sure it is
supported by the Button Stop. Proceed to the wiring steps in the
(Step 2 Continued)
next step. Once you are complete with the wiring there is nothing to
do with Lanyard. The Lanyard will push into the junction box when
the fixture is placed for final mounting.
Button Stop
Lanyard
Slot
A
Ceiling Canopy
STEP 3 Make Wire Connections-
Wrap ground wire around green ground screw on the
inner backplate, no less than 2 in from the end of the wire.
Tighten .
B. Use standard wire connectors (not included) to make all wire
connections. Twist connectors until wires are tightly joined together.
Wrap each connection with approved electrical tape and carefully
stuff all the connected wires into the Outlet Box.
A. bare or green
ches
the green ground screw
Figure 3
Green Ground Screw
on the Inner Backplate
White wire
from outlet box
White wire
from fixture
Black wire from
outlet box (or Red)
Black wire
from fixture
Bare, or Green
Ground wire
from outlet box
Ground wire
from Fixture
Figure 2
Cable
D
Allen Wrench
x1
Loader