Installation Sheet

ManualsBrandsQuoizel ManualsChandeliersQuoizel Shire 5 Light 26-1/2" Wide Chandelier

1of2

Assembly Instruction Sheet #IS-SHR5005RK

For Style SHR5005RK

6 CORPORATE PARKWAY

GOOSE CREEK SC 29445

www quoizel com

Package Contents

Hardware Contents

Crossbar

Lock Washer

Hex Nut

Nipple

Canopy

Chain Loop

Canopy Lock

Ring

Ceiling

Canopy

Fixture Chain

Quick Link

Pleasegoto forproductcleaningtips.Gotothe selection.

(5)B10CandelabraBaseBulbs60WMaximum.

30-45minutes

Identifyandinspectallpartsbeforebeginninginstallation.Checkpackagecontentlistanddiagramsbelowtobesureallpartsare

present.Ifanypartsaremissingordamaged,donotattempttoassemble,install,oroperatethefixture.Contactcustomerserviceforreplacement

parts.

www.quoizel.com Care+Maintenance

LightSource:

EstimatedAssemblyTime:

Preparation:

ToolsRequired: Flathead screwdriver,Phillipsscrewdriver,pliers,wirecutters,wirestrippers,electricaltape,safetyglasses.

Warnings and Cautions

Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.

These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly

recommend that a licensed, professional electrician perform the installation.

Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal.

2017 QuoizelInc.

Thank you for purchasing a Quoizel product.

Need assistance with parts or assembly? Call Quoizel customer service at 1-800-645-3184

or visit us on-line at www.quoizel.com

Fixture Loop

STEP 1 Install Fixture Loop-

A. Thread the Fixture Loop (A) onto the

top center of the Fixture Body (B).

Hand tighten until snug.

ReleasedDate:2017-09-18

Fixture Body

Figure 1

STEP 2 Install the Crossbar to the junction box-

A. Attach the Crossbar (AA) to the Outlet Box with the head of the

Green Ground Screw facing you. Secure it with Outlet Box Screws

(not included), tighten until snug

Figure 2

Outlet Box

Outlet Box Screw

(not included)

Green Ground

Screw

STEP 3 Install the Canopy Chain Loop and Nipple-

A. Thread one Hex Nut (CC) to one end of the Nipple (DD) until it is at

least 0.25” from the end. Pass one Lock Washer (BB) over the end

of the Nipple (DD) and thread the Canopy Chain Loop (EE) onto the

Nipple (DD). By using pliers, thread the Hex Nut (CC) against the

Canopy Chain Loop (EE) and hand tighten until snug.

B. Thread another Hex Nut (CC) to the middle of the Nipple (DD).

Place another Lock Washer (BB) over the Nipple (DD) and then

thread the Nipple (DD) into the Crossbar (AA) until the Nipple (DD)

is about 0.375” above the Crossbar (AA).

C. Remove the Canopy Lock Ring (FF) from the Canopy Chain Loop

(EE). Place the Ceiling Canopy (II) over the Canopy Chain Loop

Step B

Step A

Figure 3

(EE) against the ceiling to

determine the correct

position of the Nipple (DD).

Thread the Canopy Lock

Ring onto the Canopy

Chain Loop (EE). Adjust the

Nipple (DD) to allow the

Ceiling Canopy (II) to rest

against the ceiling when

held in place by the Canopy

Lock Ring (FF).

D. Remove the Canopy Lock

Ring (FF) and the Ceiling

Canopy (II). Tighten the

Hex Nut (CC) against the

Crossbar (AA) to secure in

place.

Summary of content (2 pages)

PAGE 1
Assembly Instruction Sheet #IS-SHR5005RK For Style SHR5005RK 6 CORPORATE PARKWAY GOOSE CREEK , SC . 29445 www . quoizel . com Please go to www.quoizel.com for product cleaning tips. Go to the Care + Maintenance selection. Tools Required: Flathead screwdriver, Phillips screwdriver, pliers, wire cutters, wire strippers, electrical tape, safety glasses. Light Source: (5) B10 Candelabra Base Bulbs 60W Maximum.
PAGE 2
STEP 4 - Install the Fixture Chain and Ceiling Canopy STEP 6 - Install Bulbs A. Adjust the Fixture Chain (GG) to your desired length by removing links if needed. B. Pull the supply wires through the Fixture Chain (GG) alternating links. After the wires are through the Fixture Chain (GG), pull the Supply Wires and the Ground Wire through the Canopy Lock Ring (FF) and the Ceiling Canopy (II) in order. C. Attach one end of the Fixture Chain (GG) to the Fixture Loop with one Quick Link (HH).