Installation Guide

INSTRUCTION SHEET IS-SMT1612

STYLE NUMBER: XXSMT1612

ISSUED 03-2011

PACKAGE CONTENTS

PART

DESCRIPTION

QUANTITY

6 CORPORATE PARKWAY

GOOSE CREEK SC 29445

www quoizel com

1pc

WARNING:

CAUTION:

● Before beginning the installation, turn off electricity at the circuit breaker box or the main fuse box by switching

off the circuit breaker or removing the fuse.

● These instructions are provided for your safety. It is very important that they are read completely before the

installation of your fixture. We strongly recommend that a professional electrician install the fixture.

● Disconnect fixture from the power source before replacing the bulb(s), making sure that bulb(s) had sufficient

time to cool down. DO NOT subject the lamp to any shock while lit as shattering of lamp may result.

WARNINGS AND CAUTIONS

1OF3

PREPARATION

● Before beginning installation of product, make sure all parts are present. Compare parts with package contents

list and diagram above. If any part is missing or damaged, do not attempt to assemble, install or operate the

product. Contact customer service for replacement part.

● Estimated Assembly Time: 15-20 minutes

● Tool Required for Assembly (not included): Flathead screwdriver, Phillips screwdriver, Pliers, Electrical tape,

Wire cutter, Safety glasses and (1) 100W Type-A medium base bulb

● Helpful Tools (not included): Wire strippers.

Crossbar

Green Ground Screw

Lock Washer

Hex Nut

Nipple

Flat Washer

Finial

Ceiling Canopy

Shade

1pc

2pcs

1pc

PAGE 1
6 CORPORATE PARKWAY GOOSE CREEK , SC . 29445 www . quoizel .
PAGE 2
INSTALLATION INSTRUCTIONS STYLE NUMBER: SMT1612XX STEP 1: a . Locate the Crossbar and attach it to the Outlet Box using the Outlet Box Screws ( not supplied ) . b . Locate the Nipple and thread one Hex Nut onto it about half way. Slip a Lock Washer onto it and thread one end of the nipple into the center hole of the Crossbar . c . Position the Ceiling Canopy over the outlet box, passing the mounting hole in the center of the Ceiling Canopy over the end of Nipple . d . Adjust the Nipple so approx .
PAGE 3
INSTALLATION INSTRUCTIONS STYLE NUMBER: SMT1612XX STEP 4 : a . Position the Ceiling Canopy to the ceiling by passing the Nipple through the center hole . b . Slip on the Flat Washer and then thread the Finial to the bottom end of the Nipple . Snug down assembly until the Ceiling Canopy is flush against the ceiling . * Be sure that there are no trapped or pinched wires along the edge of the pan. Nipple Ceiling Canopy Flat Washer Finial STEP 5 : a.