Installation Sheet

1. Make sure the wiring is safely inside the
outlet box as instructed in Step 5 -
Electrical Connections. To install the
canopy, slide the canopy up to hanger
bracket and place the key hole on the
canopy over the screw on the hanger
bracket, turn canopy until it locks in place
at the narrow section of the key holes. (Fig.
15) Align the circular hole on canopy with
the remaining hole on the hanger bracket,
secure by tightening the two set screws, lift
canopy cover and attach by turning
clockwise. Note: Adjust the canopy screws
as necessary until the canopy and canopy
cover are snug. (Fig. 15)
2. Attaching the Control Cup Plate
Attach the control cup plate to the flange of
the motor by using the three screws
provided that are pre-installed on the flange.
(Fig. 16)
3. Attaching the Control Cup
Snap together the cannon plugs and signal
cable plug, attach the control cup to the
control cup plate with the three screws
provided. (Fig. 17)
8. COMPLETING THE INSTALLATION
Fig. 16
Fig. 17
Fig. 15
Outlet box
Hanger
bracket
Canopy
Canopy cover
Screws
Screws
Control cup
Control
cup plate
Screws
Cannon plug
Signal cable
plug
Screws
Fiange
Control cup
plate