Installation Sheet

Option 2:
Close-to-Ceiling Mounting
1. Remove the decorative canopy bottom
cover from the canopy by turning the
canopy bottom cover counterclockwise
(Figure 8).
2. Remove three of the six screws and
lock washers (every other one) securing
the reinforcing plate to the top of the fan
motor housing (Figure 9).
3. Route the wires exiting the top of the
fan motor through the canopy.Place the
metal plate and ceiling canopy over the
yoke at the top of the motor. (Figure 10)
4. Align the mounting holes with the
holes in the motor and fasten using the
screws and lock washers removed in step
4 (Fig. 10).
5. Tighten the mounting screws security.
6. Hang the fan on the hook of the hanger
bracket. Be certain that the canopy is fully
locked into hook as shown in Fig. 11.
Fig. 10
Fig. 11
Fig. 9
Fig. 8
Motor
Collar
Screw and Lock Washer
(3 of 6 Places)
Metal
plate
Canopy
Bottom
Cover
Remove
Ceiling
Canopy
Screw and
Lock Washer
(3 Places)
Hook