Installation Sheet

1. Finishing the Fan Installation
Make sure the wiring is safely inside the
outlet box as instructed in Step 5 -
Electrical Connections.
Standard Ceiling Mounting
Slide canopy up to the ceiling as shown in
Figure 13. Make sure you place the wires
safely into the outlet box. Secure the canopy
to the hanger bracket with the four screws
with your fan.
Close-to-Ceiling Mounting
Remove the fan from the hook on the hanger
bracket. Secure the canopy to the hanger
bracket with four screws included with your
fan. (Fig. 13a)
2. Blade Assembly & Installation (Fig. 14)
Insert one fan blade into the blade slot on the
motor housing and secure with the blade
support plates and screws. Securely tighten
screws. Repeat process with other blades. DO
NOT bend the blade arms when
installing the blades.
3. Attaching the Control Cup
Attach the control cup plate to the flange of
the motor by using the three screws
provided that are pre-installed on the flange.
(Fig. 15) Snap together the cannon plug,
attach the control cup to the control cup
plate with the three screws provided. (Fig.
16)
A certain amount of wobble may be
considered normal, especially if the fan is
on a downrod long than 12".
6. COMPLETING THE INSTALLATION
Fig. 15
Fig. 16
Fig. 13
Canopy
Outlet Box
Hanger
Bracket
Screws
Canopy
Ring
Fig. 13a
Fig. 14
Blade
support
plate
Slot
Blades
Screws
Screws
Control
cup plate
Fiange
Screws
Control cup
Cannon plug
Control cup plate
Canopy
Outlet Box
Hanger
Bracket
Screws