Cut Sheet

LED BOLLARD INSTALLATION INSTRUCTIONS
IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
RAB xtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper
grounding is required for safety. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE
INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT
AND THE HAZARDS INVOLVED.
WARNING: Make certain power is OFF before installing or maintaining xture. No user serviceable parts
inside.
Thank you for buying RAB lighting
xtures. Our goal is to design the
best quality products to get the job
done right. We’d like to hear your
comments. Call the Marketing
Department at 888-RAB-1000, or
email: [e-mail]
LOCATION
1. The Bollard should be mounted to a rm level
surface.
2. Anchor bolts may be used in new concrete
installations. Use the provided template.
3. For all other applications use anchors suitable for
the mounting surface.
ANCHOR BOLTS INSTALLATION
CAUTION: Install according to all applicable local codes.
1. Install two Anchor Bolts in concrete foundation (by
others) using the template provided. Mounting Plate
may be used as template. Anchor Bolts should
protrude no more than 3”.
Concrete
Conduit
Anchor
Bolts
Mounting
Plate
MOUNTING fIXTURES
Depending on your model one or two xtures can be
mounted to each bollard.
1. Loosen three Door Screws and remove the Door.
2. Use the two #10-24 x 3/4” Mounting Screws to
thread into the Bollard extrusion.
3. Use the nuts and lockwashers provided to secure the
screws from inside the Bollard. Tighten securely.
4. Make sure the Housing Gaskets are properly
positioned.
5. Make electrical connections from the supply wires to
the xtures using approved connectors. Strain relief
the wires.
6. Replace the Door. Tighten screws.
7. Install the Bollard Cap and Gasket and tighten the
two set screws.
Bollard
Door
Screws
Bollard
Cap
Gasket
Door
Housing
Gaskets
Mounting
Screws