Specifications

Installation and Operation Manual Chapter 4 Configuration
ASMi-31 Ver. 3.0 Configuring the DTE Parameters 4-5
MODE
FORMAT
DATARATE
CNT SIG-DCD
CNT SIG-DSR
RLB
LLB
DTE CONFIG
*ASYNC
SYNC
MODE
A
SYNC
Figure 4-5. Selecting Transmission Mode
Configuring Data Format
When operating in asynchronous mode, ASMi-31 allows you to configure the
following data format parameters:
• Number of data bits
 7 or 8 for RAD proprietary rate adaptation method
 5, 6, 7 or 8 for V.110 rate adaptation method
• Parity (odd, even or none)
• Number of stop bits (1 or 2).
 To select asynchronous data format:
1. Press the CURSOR button to move the cursor to the Menu Type field.
2. Press the SCROLL button until DTE CONFIG is displayed.
3. Press the CURSOR button to move the cursor to the Menu Options field.
4. Press the SCROLL button until FORMAT is displayed (see
Figure 4-6 ).
5. Press the CURSOR button to move the cursor to the Parameters field.
6. Using the SCROLL button, select appropriate data format and press the
ENTER button to set your choice.
 7B NP 1S refers to 7 bits, no parity, 1 stop bit.
 8B EP 2S refers to 8 bits, even parity, 2 stop bits, and so on.