User's Manual
Table Of Contents
- Front Matter
- Quick Start Guide
- Contents
- Chapter 1 Introduction
- Chapter 2 Installation and Setup
- Chapter 3 Operation
- Chapter 4 Configuration
- Chapter 5 Setup Menu
- Chapter 6 Troubleshooting and Diagnostics
- Appendix A Interface Specifications and Cable Diagrams
- Appendix B Boot Manager
- Appendix C SNMP Management
- Appendix D Glossary
- DC Power Supply Connection
- Customer Response Form
Chapter 5 Setup Menu FCD-IPM Installation and Operation Manual
5-26 Interface Parameters Menu
5.3 Interface Parameters Menu
Select this option to set general parameters and link, Frame Relay, ISDN or E1/T1
parameters.
The Interface Parameters menu is dynamic, depending on the hardware
configuration. Only those screens / parameters that are applicable to your interface
will appear.
Interface Parameters
3
1. Asynchronous
1. Status
2. Type
3. Connection
Type
4. Connection
Timeout (sec)
5. Control
Signals Mode
6. Clock
Rate
1
Link
Settings
2
Device Control
1
Setup
Advanced Menu
5
Frame
Relay
Settings
E1/T1
Settings
3
4
ISDN
Settings
1. Clock
Master
2. Multiplier
4. General
Diagnostics
5. E1/T1
Parameters
7. Alarms
Filter
3. Time Slots
Mapping
3. Frame Relay
2.Synchronous
8. Advanced
Setup
6. Additional
Cards Parameters
SHDSL
Settings
2
1. SHDSL
Parameters
1. Line Mode
2. Standard
3. PSD
4. SNR Margin
5. SNR Margin
Threshhold
6. Loop Attenuation
Threshhold
2. SHDSL
Loops
Figure 5-30. Interface Parameters Menu Outline
To access the Interface Parameters menu:
1. In the Advanced Menu, press 1.
The Setup menu appears.
2. In the Setup menu, press 3.
The Interface Parameters menu appears.