User's Manual
Table Of Contents
- Front Matter
- Quick Start Guide
- Contents
- Chapter 1 Introduction
- Chapter 2 Installation and Setup
- Chapter 3 Operation
- Chapter 4 Configuration
- Chapter 5 Setup Menu
- Chapter 6 Troubleshooting and Diagnostics
- Appendix A Interface Specifications and Cable Diagrams
- Appendix B Boot Manager
- Appendix C SNMP Management
- Appendix D Glossary
- DC Power Supply Connection
- Customer Response Form
FCD-IPM Installation and Operation Manual Chapter 5 Setup Menu
Interface Parameters Menu 5-27
INTERFACE PARAMETERS (Device name - FCD-IPM)
1. Link settings
2. SHDSL settings
3. E1, T1, voice settings
4. ISDN settings
5. Frame relay settings
ESC - return to previous menu
Choose one of the above:
Figure 5-31. Interface Parameters
The options in the Interface Parameters menu are described below.
Link Settings Menu
INTERFACE PARAMETERS ( Device name - 27 )
1. Link settings
2. E1, T1, voice settings
Press number to select or ESC to return to the previous menu:
Figure 5-32. Link Settings Menu
The Link Settings Menu lists parameters that are specific to the line hardware. The
Menu is dynamic, depending on which hardware interface and protocol you have
ordered.
The parameters that follow apply to all link types.
Advanced Menu
↓1
Setup Menu
↓3
Interface Parameters Menu
↓1
Link Settings Menu